Go to the block diagram, and wire a False to the Reset? input of the Initialize VI, and delete the autosetup VI. Here's how to make the example work for you. Note that this example changes your trigger source from EXT to C1. You received the timeout either because a) the autosetup took longer than the timeout value selected, or because b) you didn't have a signal in the specified channel that the scope could trigger on. The example "lcwave acquire waveform" will reset the scope to the "default setup", and perform an autosetup. For TCP/IP connections, you should use the connection string beginning with VICP. I seem to be getting through to the scope - however something is going wrong!Īnd by the way, i could not find any of the example vi's under ni example finder - I had to open the lcwave.llb file and run the vi from there. I get a much wilder effect, the scope goes into a "auto setup" mode, activates channel 2 and set trigger on channel 1 (i trigger on external).Īnd after a few seconds i get this error:Įrror -1073807339 occurred at Timeout expired before operation completed. I choose channel 1, on which i just had random noise.Īfter hitting run i get the error: Error - 1074003951 occurred at an unidentified location I have just now tried "lcwave acquire waveform". I have already installed the VISA, the lecroy "passport" and copied the lcwave into a folder under instr.lib on my computer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |